http://chomsky.shampoo.ca/goldenembed

   This is the firmware for the Golden Embed GPS project. Please note that all 
the code here is under the GPL.

   This firmware runs off Sparkfun's Package Tracker: 
http://www.sparkfun.com/products/8755 and requires the nRF2401A  
http://www.sparkfun.com/products/153

   You will also need a LiPo battery, a Mini B 5 pin USB cable and an SD card.

   To get an idea on how to solder the pieces together, see the following: 
http://www.flickr.com/photos/42018184@N00/sets/72157623403983166/

   To build this firmware you must install either WinARM: 
http://www.siwawi.arubi.uni-kl.de/avr_projects/arm_projects/ or 
GnuARM: http://www.gnuarm.com/ for Linux and OS X.

   Once you have the firmware built, simply copy the the FW.SFE to a FAT16
formatted (important) SD card loaded in your Logomatic. Then simply pull out
the USB cable. This will force the boot loader to load up the firmware.

   The stat lights will blink to indicate that the firmware has started.  Then,
after a few seconds and after the GPS has obtained a lock you should see each
stat light blink indicating that it is writing to disk. You obviously need an
ANT+ device to be in range.

   The result will be ANT+ messages plus a time stamp tailed to the end of each 
ANT+ message. To parse this message you may write your own parser or use the 
Java parser found here: http://github.com/jknotzke/GoldenEmbedParser (gps branch)

   If you have questions, patches there is a mailing list: 
http://groups.google.com/group/goldenembed