Support for the DHT11 and DHT22 temperature and humidity sensor.
This plugin requires the BCM2835 library to be installed on your Raspberry Pi before you can actually use this module.!
Add the plugin to the plugin section:
{
"plugin": "dht-sensors"
}Add a DHTSensor device for your sensor to the devices section. To initialize the sensor,
you have to specify the sensor type and the GPIO pin where the sensor is connected to.
It should work for DHT11, DHT22 and AM2302 sensors. The type property need to bet set as follows:
| Value | Sensor |
|---|---|
| 11 | DHT11 |
| 22 | DHT22 or AM2302 |
By default, the WiringPi pin numbering scheme is used assuming a Revision 2
board which is identifiable by the presence of the 2 mounting holes next to the ends to
GPIO pin header. Alternatively, you can set the pinType to "BCM GPIO" for
BCM pin numbering or "WiringPi R1" for WiringPi pin numbering
on a Revision 1 board.
{
"id": "my-sensor",
"name": "dht22 example",
"class": "DHTSensor",
"type": 22,
"pin": 7,
"interval": 60000
}