eeprom-programmer

An Arduino Nano sketch and schematic for an Atmel 28cx programmer. The schematic started out only targeting 8kx8 chips (rev. A) but has been updated to connect all address lines for the 28cx series (rev. B), so any of those eeproms should work up to the 32kx8 chips. The design is based on this one, from Ben Eater.

The Arduino Nano sketch implements a serial interface to the programmer. It accepts one-letter commands:

e - erase the eeprom
f - fill eeprom with incrementing bytes
h - help (this) text
l - lock the eeprom against writes
r - read and dump eeprom contents
s - set the size of the eeprom
u - unlock eeprom writes
v - software version info
x - xmodem transfer binary file to eeprom

Any standard terminal program can be used to talk to the programmer. I use the following:

serial for the Mac
teraterm for Windows
minicom for Linux

Be sure to set the size of your target eeprom with the s command before doing anything. It doesn't affect the chip in any way, but tells the programmer what size your chip is for the erase, fill and read commands and error checking in the xmodem transfer.

The programmer uses standard x-modem, as provided by any respectable terminal program—and certainly all of the above listed terminal programs—to put binary files onto the eeprom. No other software is required. The programmer will verify every 64 bytes as they are written (the size of an internal eeprom page).

Although the eeprom chips are supposed to come from the factory unlocked, I've heard stories of some chips being purchased off ebay that arrive locked. Try doing an unlock on a chip if you have problems writing to it.

When doing an xmodem transfer to the chip, the program will wait indefinitely for you to start the xmodem transfer from your terminal software. You can abort the transfer at this point by pressing the ESC key. Otherwise, once you have started the transfer, it will continue until the process completes or an error is detected.

If you want to fill the eeprom with a specific byte, say the 6502 nop 0xea, just change

fill[j] = i + j;

on line 490 to

fill[j] = 0xea;

License

yoppeh/eeprom-programmer

ErrorLooks like something went wrong!

About

Topics

Resources

License

Uh oh!

Stars

Watchers

Forks

Releases

Packages 0

Uh oh!

Languages

Error
Looks like something went wrong!

Packages