MCC generated code for i2c read and write operations with interrupts.

A code example that shows how to configure the ADCC to read a single analog value.

PIC18F47Q10 PWM RGB-LED Using Interrupts - bare metal code example

The PIC18F47Q10 features two MSSP modules, which can be configured in SPI mode. In this demo, the SPI is configured as slave and it is used to exchange data. The data transfer is triggered by interrupts. The repository contains the bare metal code for the application.

This repository provides an example of bare-metal code for GPIO read/write operations. This example shows how to read an input pin value, changed by pressing a button, and how to set an output pin value, in order to turn an LED on and off.

The PIC18F47Q10 features two MSSP modules, which can be configured in SPI mode. In this demo, the SPI is configured as master and sends data to two slave devices, one at a time. The repository contains the Foundation Services Generated code for the application.

This repository provides a MCC-generated code example for using TMR0 in 8-bit Mode with clock output. A signal will be generated using TMR0 on the output RC2 pin.

Code example for "Getting Started with CLC on PIC18" Technical Brief : Using Basic Logic Gates - Bare Metal Code

This example shows how to send a string to the PC and see it in the MPLAB Data Visualizer Terminal.

PIC18F47Q10 PWM Basic Configuration - bare metal

This repository provides an example of bare-metal code for a Wake-Up from Sleep procedure. This example shows how to obtain less power consumption by putting the device in the Sleep mode and waking it up using the IOC, with a button controlling the input pin value.

A code examples that shows how to configure the ADCC to read one analog value.

Foundation Services generated code for i2c write operation.

A code example that configures the ADCC to provide an interrupt when a sharp increase or decrease is detected in the sampled value.

Bare metal code for i2c read and write operations with interrupts.

A code example that configures the ADCC to provide a measurement of the internal temperature of the microcontroller.

Neste projeto foram desenvolvidos um programa em C e Assembly com o objetivo de implementar diferentes aplicações num microcontrolador. O projeto final, intitulado "sensor", consistiu na criação de um sensor ótico destinado à deteção de movimentos respiratórios em pacientes com apneia do sono.

This repository provides a bare-metal code example for using TMR4 peripheral as a Hardware Limit Timer in order to generate an interrupt and stop TMR2 that also stops the ADCC auto-conversion.

MCC generated code for i2c write operation

This example shows how to use the printf function to send messages over EUSART and display charts in MPLAX Data Visualizer using Data Stream Protocol.