Skip to content

ESP32 RF Send and Receive

Florian edited this page Feb 27, 2019 · 7 revisions

ESP32 - RF Send and Receive

Prerequisites

Note: Gateways can be used separately. Follow this Link for a quick overview about all Modules and possible Combinations.

Tested Modules for the RF Addon:

Module Purpose Where to Buy
XD RF 5V 433Mhz Receiver parts list
FS1000A 433Mhz Transmitter parts list
  • or better alternative superheterodyne STX882 & SRX882

Hardware setup:

Module Pin ESP32 RX Pin ESP32 TX Pin
RF Receive Module data pin 27 -
RF Send Module data pin - 12

Vcc pin of the ESP32, the RF Emitter and RF Receiver to a 5V supply source Ground pins of the ESP32, the RF Emitter and RF Receiver to the ground of the supply source.

Addon_RF

Software setup:

For the libraries take the version linked into Lib folder

If you want to use this gateway uncomment in user_config

#define ZgatewayRF

If you want to use KAKU protocol uncomment also #define ZgatewayRF2

If you want to use the protocols supported by Pilight library comment also #define ZgatewayRF2 #define ZgatewayRF and uncomment #define ZgatewayPiLight

For your first tests comment the others Zgateway.

Notice that ESP32 dev environnement is still moving and should be considered for beta usage and not production usage in my point of view.

Clone this wiki locally
You can’t perform that action at this time.
You signed in with another tab or window. Reload to refresh your session. You signed out in another tab or window. Reload to refresh your session.