Skip to content

@leon-anavi leon-anavi released this Jan 9, 2020

Release 2.0.0 brings the following new features and improvements for ANAVI Light Controller:

  • Support Home Assistant automatic discovery over MQTT
  • Turn on LED D1 on ANAVI Light Controller if the device is not connected to local WiFi network and needs initial configuration
  • Wait for a few seconds while LED D1 is blinking immediately after turning on ANAVI Light Controller to allow reset by keeping SW1 pressed
  • Append the last 5 characters of the machine ID to the WiFi Access Point (AP) to simplify the identification of the ANAVI Light Controller during the initial setup
  • Support MQTT messages with large payload for reporting back the current state of the RGB LED strips on topic stat/dev-id/color
  • Add DEBUG macros, disabled by default, if enabled additional debug information will be printed in the serial monitor
Assets 3
You can’t perform that action at this time.