Skip to content
Permalink
Branch: master
Find file Copy path
Find file Copy path
Fetching contributors…
Cannot retrieve contributors at this time
54 lines (34 sloc) 2.5 KB

Examples of nanoindentation data

Warning

Only square or rectangular indentation grids can be loaded into the |matlab| toolbox.

Warning

Only .xls or .xlsx file can be loaded into the |matlab| toolbox. Or |matlab| code has to be updated. See the section 'New results file' below.

Note

For 2D maps, only a sheet with average values at a given indentation depth is enough. But for a 3D mapping, sheet with mechanical properties as a function of indentation depth are required.

File examples from 'MTS/Agilent'

For a 2D map: MTS_example1_25x25.xls

For a 3D map: MTS_example3_5x5_testSlice.xlsx

File example from 'Hysitron'

For a 2D map: Hysitron_example_10x10.xlsx

File example from 'ASMEC'

For a 2D map: ASMEC_example_20x11.xlsx

File example after crop and interpolation steps

For a 2D map: MTS_example1_25x25.xls_interp_81x81.xls Don't forget to set 'Agilent' for the equipment, when you load an .xls file generated using the TriDiMap GUI.

New results file

In case of other or new experimental results file, the most important is to know the pattern of the indentation grid. For example, the following figure shows the pattern of a typical indentation grid obtained using the software (e.g. Testworks...) of MTS/Agilent.

The |matlab| function to modify to load specific indentation results file is: TriDiMap_loadingAllTests.m

Contact me, in case of special data file format.

./_pictures/MTS_indentationGrid.png

Example of indentation grid pattern using a MTS/Agilent nanoindenter

You can’t perform that action at this time.