You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I'm working with the laser cutting (NHS visors) this evening, David and I noticed the laser is set to 100% power and the advisory sticky note says it should be 70%.
Please could the relevant person confirm the correct power setting? I will leave the setting at 100% until otherwise instructed i.e. the cuts are coming out fine etc.
Regards
The text was updated successfully, but these errors were encountered:
As mentioned on the other ticket (thanks @huffeec !) This is correct, the laser cutter's screen should report 100% while the computer settings should be 70.
I'm working with the laser cutting (NHS visors) this evening, David and I noticed the laser is set to 100% power and the advisory sticky note says it should be 70%.
Please could the relevant person confirm the correct power setting? I will leave the setting at 100% until otherwise instructed i.e. the cuts are coming out fine etc.
Regards
The text was updated successfully, but these errors were encountered: