CutEtchSettingsGerald

Adrian McEwen edited this page Aug 17, 2017 · 2 revisions

Cut/Etch Settings Gerald

3040 (tube)

Cut/Etch Settings Etch Speed Etch power Cut speed Cut power(/corner) Date last confirmed
3mm Birch Plywood 10 70 (60) (19/3/2014)
3mm Acrylic 10 70 (70)
1.3mm Mountboard (bought downstairs) 70 60 (60)
1.5mm Laminated Perspex (AMc's Tested Settings - etches through to next colour) 200 15 25 50(30)
24mm Plastazote Foam 250 25 18 70(70)
General Walnut veneer 50 22
Fine Detail Walnut veneer 25 20
6mm MDF 4 50 (40) 11/4/2014
10mm circa Slate 200 24 (20) 23/4/2014
5.50-5.75mm Carpet (The best result with carpet has been obtained with two cutting passes. One with speed set to 20 and a second one with speed set to 10) 20 and 10 70 (60) 28/4/2014
2mm HIPS High Impact Polystyrene 5 22(12) 5/5/2014
2mm Acetal (Delrin) 250 40 18 70 (70)
Clone this wiki locally
You can’t perform that action at this time.
You signed in with another tab or window. Reload to refresh your session. You signed out in another tab or window. Reload to refresh your session.
Press h to open a hovercard with more details.