Permalink
Browse files

Updated readme.md

  • Loading branch information...
1 parent 8e6d1d3 commit 616e14161682394aefe4b5d63734358c8f04c449 @ErikZalm committed May 19, 2012
Showing with 7 additions and 7 deletions.
  1. +7 −7 README.md
View
@@ -1,10 +1,10 @@
WARNING:
--------
-THIS IS RELEASE CANDIDATE 2 FOR MARLIN 1.0.0
+THIS IS RELEASE CANDIDATE 3 FOR MARLIN 1.0.0
+
+Only arduino 1.0 is supported.
+If you are using arduino 0022 or 0023 switch to arduino 1.0.
-The configuration is now split in two files
-Configuration.h for the normal settings
-Configuration_adv.h for the advanced settings
Gen7T is not supported.
@@ -74,13 +74,13 @@ To reduce noise and make the PID-differential term more useful, 16 ADC conversio
If your gcode contains a wide spread of extruder velocities, or you realtime change the building speed, the temperature should be changed accordingly.
Usually, higher speed requires higher temperature.
This can now be performed by the AutoTemp function
-By calling M109 S<mintemp> T<maxtemp> F<factor> you enter the autotemp mode.
+By calling M109 S<mintemp> B<maxtemp> F<factor> you enter the autotemp mode.
You can leave it by calling M109 without any F.
If active, the maximal extruder stepper rate of all buffered moves will be calculated, and named "maxerate" [steps/sec].
The wanted temperature then will be set to t=tempmin+factor*maxerate, while being limited between tempmin and tempmax.
If the target temperature is set manually or by gcode to a value less then tempmin, it will be kept without change.
-Ideally, your gcode can be completely free of temperature controls, apart from a M109 S T F in the start.gcode, and a M109 S0 in the end.gcode.
+Ideally, your gcode can be completely free of temperature controls, apart from a M109 S B F in the start.gcode, and a M109 S0 in the end.gcode.
*EEPROM:*
@@ -175,7 +175,7 @@ MISC:
Configuring and compilation:
============================
-Install the arduino software IDE/toolset v22
+Install the arduino software IDE/toolset v1.0
http://www.arduino.cc/en/Main/Software
For gen6 and sanguinololu the Sanguino directory in the Marlin dir needs to be copied to the arduino environment.

0 comments on commit 616e141

Please sign in to comment.