Skip to content

GA1.5 Engineering Release
Compare
Choose a tag to compare
@greg-leach greg-leach released this 17 Apr 10:21
· 2 commits to main since this release
GA1.5
1daebb9
This commit was signed with the committer’s verified signature.
nhopcroft Neil Hopcroft
GPG key ID: A9BE94CE4D7A80B9
Verified
Learn about vigilant mode.

Bugfixes:

  • Potential lock up condition where a non-terminated message is sent to a module in low power mode resolved (PROD-15119)
  • Mapping added for bandwidth ATI parameter (PROD-12894)
  • Mapping added for spreading factor ATI parameter (PROD-12895)
  • Mapping added for modulation type ATI parameter (PROD-12896)
  • Mapping added for device address ATI parameter (PROD-12953)
  • Formatting of AT responses corrected (PROD-14029)
  • Formatting of aysnchronous messages corrected (PROD-14529)
  • DevEUI is no longer reset to default value following an AT&F command (PROD-15611)
  • Connection indication pin now indicates device connection status when configured (PROD-19852)
  • Radio activity now being reported correctly (PROD-14021)
  • Application state now being reported correctly (PROD-14027)
  • Confirmed Packet retry mechanism now operates correctly (PROD-21935)

New Features:

  • Added TX Power Limit feature (PROD-6433)
  • Added Static ADR mode (PROD-6435)
  • Added wake up preamble feature for hosts with long wake up time (PROD-12955)
  • Added AT+BAT command for DevStatusReq response battery information population (PROD-12983)
  • Added AT+DUTY command for payload size limit determination (PROD-13938)
  • Added AT+SUPS and SUPC commands for power supply measurement scheduling (PROD-14094)
  • Added AT+SUPI command for immediate power supply measurement (PROD-14781)
  • Added AT+TEMP command for module temperature measurement (PROD-15118)
  • Added AT+CRX and AT+CTX commands for factory test functionality (PROD-15828, PROD-15829)
  • Added AT+SLEEP command for immediate low power mode entry (PROD-16129)
  • ADRI, ADRJ and ADRX asynchronous messages added to detail ADR related parameter changes (PROD-12920)

Changes:

  • Updated to Semtech Basics Modem v4.5 (PROD-6426)
  • NZ915 region has been removed due to complexity of gateway setup (PROD-10118)
  • UART Idle Time lower limit has been reduced to 100ms (PROD-14838)
  • Device Management uplinks on port 199 removed (PROD-6426)
  • Radio State and Application State ATI parameter values adjusted to make content of both unique (PROD-14021, PROD-14027)
  • Defaults for P2P Datarate & P2P Beacon Datarate set to 2 to prevent possible hardfault when module region is changed (PROD-24793)
  • Order of TX and RX messages changed to TX followed by RX (PROD-22751)
  • Part numbers of AT Interface firmware and Factory Images harmonised (PROD-26759)

Known Issues:

  • P2P mode to be implemented for JP923 (PROD-25017)
  • P2P range to be optimised (PROD-25018)
Assets 9
Loading