Skip to content
Permalink
Branch: master
Find file Copy path
Find file Copy path
Fetching contributors…
Cannot retrieve contributors at this time
85 lines (73 sloc) 1.6 KB
# This file contains common pin mappings for Printrboard boards (rev B
# through D). To use this config the firmware should be compiled for
# the AVR at90usb1286.
# Note that the "make flash" command is unlikely to work on the
# Printrboard. See the RepRap Printrboard wiki page for instructions
# on flashing.
# See the example.cfg file for a description of available parameters.
[stepper_x]
step_pin: PA0
dir_pin: !PA1
enable_pin: !PE7
step_distance: .0125
endstop_pin: ^PE3
position_endstop: 0
position_max: 200
homing_speed: 50
[stepper_y]
step_pin: PA2
dir_pin: PA3
enable_pin: !PE6
step_distance: .0125
endstop_pin: ^PB0
position_endstop: 0
position_max: 200
homing_speed: 50
[stepper_z]
step_pin: PA4
dir_pin: !PA5
enable_pin: !PC7
step_distance: .0025
endstop_pin: ^PE4
position_endstop: 0.5
position_max: 200
[extruder]
step_pin: PA6
dir_pin: PA7
enable_pin: !PC3
step_distance: .002
nozzle_diameter: 0.400
filament_diameter: 1.750
heater_pin: PC5
sensor_type: EPCOS 100K B57560G104F
sensor_pin: PF1
control: pid
pid_Kp: 22.2
pid_Ki: 1.08
pid_Kd: 114
min_temp: 0
max_temp: 250
[heater_bed]
heater_pin: PC4
sensor_type: EPCOS 100K B57560G104F
sensor_pin: PF0
control: watermark
min_temp: 0
max_temp: 130
[fan]
pin: PC6
[mcu]
serial: /dev/serial/by-id/usb-Klipper_Klipper_firmware_12345-if00
[printer]
kinematics: cartesian
max_velocity: 300
max_accel: 3000
max_z_velocity: 5
max_z_accel: 100
# Use the following on a Printrboard RevF to control stepper current.
#[mcp4728 stepper_current_dac]
#scale: 2.327
#channel_a: 1.2 # Extruder
#channel_b: 1.2 # stepper_z
#channel_c: 1.0 # stepper_y
#channel_d: 1.0 # stepper_x
You can’t perform that action at this time.