Skip to content
Permalink
Branch: master
Find file Copy path
Find file Copy path
Fetching contributors…
Cannot retrieve contributors at this time
87 lines (75 sloc) 1.88 KB
# This file contains an example configuration with three
# micro-controllers simultaneously controlling a single printer.
# See both the example.cfg and example-extras.cfg file for a
# description of available parameters.
# The main micro-controller is used as the timing source for all the
# micro-controllers on the printer. Typically, both the X and Y axes
# are connected to the main micro-controller.
[mcu]
serial: /dev/serial/by-path/platform-3f980000.usb-usb-0:1.2:1.0-port0
pin_map: arduino
# The "zboard" micro-controller will be used to control the Z axis.
[mcu zboard]
serial: /dev/serial/by-path/platform-3f980000.usb-usb-0:1.3:1.0-port0
pin_map: arduino
# The "auxboard" micro-controller will be used to control the heaters.
[mcu auxboard]
serial: /dev/serial/by-path/platform-3f980000.usb-usb-0:1.4:1.0-port0
pin_map: arduino
[stepper_x]
step_pin: ar54
dir_pin: ar55
enable_pin: !ar38
step_distance: .0125
endstop_pin: ^ar3
position_endstop: 0
position_max: 200
homing_speed: 50
[stepper_y]
step_pin: ar60
dir_pin: !ar61
enable_pin: !ar56
step_distance: .0125
endstop_pin: ^ar14
position_endstop: 0
position_max: 200
homing_speed: 50
[stepper_z]
step_pin: zboard:ar46
dir_pin: zboard:ar48
enable_pin: !zboard:ar62
step_distance: .0025
endstop_pin: ^zboard:ar18
position_endstop: 0.5
position_max: 200
[extruder]
step_pin: auxboard:ar26
dir_pin: auxboard:ar28
enable_pin: !auxboard:ar24
step_distance: .002
nozzle_diameter: 0.400
filament_diameter: 1.750
heater_pin: auxboard:ar10
sensor_type: EPCOS 100K B57560G104F
sensor_pin: auxboard:analog13
control: pid
pid_Kp: 22.2
pid_Ki: 1.08
pid_Kd: 114
min_temp: 0
max_temp: 250
[heater_bed]
heater_pin: auxboard:ar8
sensor_type: EPCOS 100K B57560G104F
sensor_pin: auxboard:analog14
control: watermark
min_temp: 0
max_temp: 130
[fan]
pin: auxboard:ar9
[printer]
kinematics: cartesian
max_velocity: 300
max_accel: 3000
max_z_velocity: 5
max_z_accel: 100
You can’t perform that action at this time.