diff --git a/docs/src/gui/qtvcp-widgets.adoc b/docs/src/gui/qtvcp-widgets.adoc
index 271f97d2b91..74131236b2a 100644
--- a/docs/src/gui/qtvcp-widgets.adoc
+++ b/docs/src/gui/qtvcp-widgets.adoc
@@ -1537,7 +1537,7 @@ Enter any of these _case sensitive_ commands to load the respective program or a
 *`CLEAR HISTORY`*::
   _Clears the MDI History_.
 *`net`*::
-  See link:../man/man1/halcmd.1.html#COMMANDS[`halcmd net` commands]. +
+  See link:../man/man1/halcmd.1.html#_commands[`halcmd net` commands]. +
   An error will result if the command is unsuccessful.
   * _Syntax_: `net <signal name> <pin name>`
   * __Example__: `net plasmac:jog-inhibit motion.jog-stop`
diff --git a/docs/src/man/man1/linuxcncrsh.1.adoc b/docs/src/man/man1/linuxcncrsh.1.adoc
index 424c956579f..bff8aa543e7 100644
--- a/docs/src/man/man1/linuxcncrsh.1.adoc
+++ b/docs/src/man/man1/linuxcncrsh.1.adoc
@@ -146,12 +146,12 @@ The supported commands are as follows:
 
 *get* _<subcommand>_ [_<parameters>_]::
   The 'GET' command takes one of the LinuxCNC sub-commands
-  (see link:#_linuxcnc_subcommands[*SUBCOMMANDS*] below) and zero or
+  (see link:#_subcommands[*SUBCOMMANDS*] below) and zero or
   more additional subcommand-specific parameters.
 
 *set* _<subcommand>_ [_<parameters>_]::
   The 'SET' command takes one of the LinuxCNC sub-commands
-  (see link:#_linuxcnc_subcommands[*SUBCOMMANDS*] below) and zero or
+  (see link:#_subcommands[*SUBCOMMANDS*] below) and zero or
   more additional parameters.
 
 *quit*::
@@ -164,7 +164,7 @@ The supported commands are as follows:
   The 'SHUTDOWN' command tells LinuxCNC to shutdown and disconnect the
   session. This command may only be issued if the 'HELLO' has been
   successfully negotiated and the connection has control of the CNC
-  (see 'SET ENABLE' sub-command in the link:#_linuxcnc_subcommands[*SUBCOMMANDS*]
+  (see 'SET ENABLE' sub-command in the link:#_subcommands[*SUBCOMMANDS*]
   section below).
   +
   Note that LinuxCNC will only shutdown automatically if *linuxcncrsh*