Skip to content
Simple Motion Alarm using Wemos D1 Mini and IFTTT
Branch: master
Clone or download
Eric
Latest commit f8d71b5 Aug 4, 2018
Permalink
Type Name Latest commit message Commit time
Failed to load latest commit information.
Photos Case Added Jan 7, 2018
WemosAlarmEmailV4
case Schematic and Readme Jan 9, 2018
schematic Schematic and Readme Jan 9, 2018
README.md

README.md

Erics Super Simple motion sensor alarm system using a Wemos D1 mini and Passive infra-red (PIR) sensor to send you notifications via IFTTT My Youtube Channel : http://www.youtube.com/mkmeorg My website : http://www.mkme.org

If you use this code or personalize it etc- please consider sharing it back with the world Open-Source Tested with Arduino IDE 1.6.7 Connect PIR sensor V+ to 5V , V- to GND and Signal as per the sketch below.

See the full video here: https://www.youtube.com/watch?v=y9XC5yHR5Bk

Buy the Wemos D1 Here: http://amzn.to/2lFkeA6

Buy the PIR sensor here: http://amzn.to/2lFYh3J

V1 Basic Sketch Works to send emails every 10 seconds or around there. V2 works smoke and motion V3 Wont boot if d8 high on startup- Changed to Pin 7 and this works. Levelconverter in place and tested- works perfect for 5V in Note: MQ2 draws too much for board to support and will need standalone Vref V4 Converted to IFTTT and temporarily removed smoke detection. Disabled wificlient in setup and only activate when ifttt is called

Get a 3D printable case on Thingiverse here: https://www.thingiverse.com/thing:2489968

To get your IFTTT Key: 1: sign in 2: click on your account in the top right corner 3: select services 4: select Webhooks 5: click settings in the top right 6: under account info, copy everything after https://maker.ifttt.com/use/ (including underscores)

You can’t perform that action at this time.