Skip to content
Foxbox using the Arduino UNO
C
Find file
Fetching latest commit…
Cannot retrieve the latest commit at this time.
Failed to load latest commit information.
README
README.md
foxbox.c

README.md

CW FOX BOX BY: NT1K

http://www.NT1K.com

My first project ever so give me a break

A simple project that allows you to turn your Arduino (or equiv) into a Beacon that could be used in "FoxHunting" or RDF when hooked up to a transceiver. The code will active the PTT (Through the Speaker/Mic Jack), Send tones in CW/Morse Code through the mic input, Send a solid tone (optional), de-active PTT and repeat. All can be adjusted in the code

Materials Needed

  • 3 LEDS (Optional)
  • 3 Resistors (For LEDs)
  • 1 Resistor (Value Unknown ATM)
  • 1 100mF Ceramic Cap (Not Sure ATM)
  • 1 4N34 Optoisolator (Could also use Relay)
  • 1 2.5mm MONO (TS) plug
  • 1 3.5mm Streao (TRS) plug
  • 1 SPST Push Button Switch (Normally Open)
  • 1 Arduino UNO (Or Equiv)

Board layout

Known Issues:

1: RF - When HT is transmitting, RF is distrubing the Arduino causing it to reset

2: Voltage in Audio - Noticible "hum" in audio

This is my first project involving programing and circuit design. If you make any changes please explain in detail how and why you made that change so others can learn.

Something went wrong with that request. Please try again.