Find file History
DanKoloff update
Latest commit 1b15d43 Mar 27, 2018
Type Name Latest commit message Commit time
Failed to load latest commit information.
ETH_PHY_demo Tested demos update Mar 27, 2018
MOD-OLED update Mar 27, 2018
MOD-RTC update Mar 27, 2018
sd_card Tested demos update Mar 27, 2018
toggle_relay Tested demos update Mar 27, 2018 Tested demos update Mar 27, 2018

ESP32-GATEWAY Software development

Install ESP-IDF

To run the examples in this directory or your own you'll need to get SDK from Espressif called ESP-IDF. We recommend reading their setup guide.

When IDF_PATH is in your PATH you're ready to continue with example running.

Run examples

To run our example all you need to do is:

  • Run menuconfig
    make menuconfig
* Configure serial flasher

ESP32-GATEWAY has built-in serial flasher to help users upload their projects.
Connect the board to PC via USB-micro cable. New serial device should
apear, for example **/dev/ttyUSB0**. Then in the menuconfig configure
flasher as follows:

Serial flasher config  --->
        (/dev/ttyUSB0) Default serial port
        Default baud rate (115200 baud) --->
        [*] Use compressed upload
        Flash SPI mode (DIO)  --->
        Flash SPI speed (40 MHz) --->
        Flash size (4 MB) --->
        [*] Detect flash size when flashing bootloader
        Before flashing (Reset to bootloader)  --->
        After flashing (Reset after flashing)  --->
        'make monitor' baud rate (115200 bps)  --->

* Configure example

Some examples have their own configuration menu. If it's present
you can modify the options:

Example Configuration  --->
        Select board relay to use in the example (Relay 1)  --->

Exit and save configuration.

  • Compile example To compile example run:
  • Uploading example As we previously mention uploading application is done automatically. If serial flasher is configured do:
make flash

You'll see something like this: v2.0-beta3
Flashing binaries to serial port /dev/ttyUSB0 (app at offset 0x10000)... v2.0-beta3
Uploading stub...
Running stub...
Stub running...
Configuring flash size...
Auto-detected Flash size: 4MB
Flash params set to 0x0220
Compressed 15808 bytes to 9219...
Wrote 15808 bytes (9219 compressed) at 0x00001000 in 0.8 seconds (effective 154.5 kbit/s)...
Hash of data verified.
Compressed 356080 bytes to 168292...
Wrote 356080 bytes (168292 compressed) at 0x00010000 in 14.9 seconds (effective 191.3 kbit/s)...
Hash of data verified.
Compressed 3072 bytes to 82...
Wrote 3072 bytes (82 compressed) at 0x00008000 in 0.0 seconds (effective 1905.4 kbit/s)...
Hash of data verified.

Hard resetting...

Optionally you can open serial monitor by typing:

make monitor