installation procedure

Julien MOINARD edited this page Aug 12, 2016 · 10 revisions

INSTALLING THE GUI

  • Step by step installation (Kali Linux, Debian or Uuntu & Mac Os is supported by homebrew)

    • Open a new terminal on the desktop

    open-terminal

    • Install packages needed (ruby must be >= 2.1) with the following command:
    apt-get install ruby ruby-dev cmake libsqlite3-dev dfu-util libqt4-dev
    
    • Install the gems used by Hardsploit

    if you use GCC > 5.4 you need to use GCC 5.4 at least to be sure qtbindings gem can be compile without any issue, to do that :

    export CC=gcc-5
    export CXX=g++-5
    
    gem install qtbindings activerecord libusb sqlite3

    Install the GUI by using the gem

    gem install hardsploit_gui

    That's it ! Hardsploit is now ready to be launched. Connect your board by USB and type in the terminal

    hardsploit_gui
    

    At the opening you will have in the console either this message:

    usb-ok

    Or this one:

    usb-nok

    If you have this last one, please check your USB connectivity. Don't forget that if you are using a virtual machine you have to attach Hardsploit to it. Hardsploit doesn't manage hotswap yet so you will have to

    • close the GUI
    • connect your board
    • launch the GUI again

    Hardsploit can be used without being connected but you will not have the possibility to execute commands or to use the wiring helper

For the next part it's this way

You can’t perform that action at this time.
You signed in with another tab or window. Reload to refresh your session. You signed out in another tab or window. Reload to refresh your session.
Press h to open a hovercard with more details.