Skip to content


LuxAetern edited this page Feb 1, 2017 · 2 revisions


The FABtotum accepts 1.75mm Filaments (PLA or ABS). You can find a selection of tested Filaments on the FABtotum Store These are compatible with the compartment under the right cover.

You can use spools up to a size of 200mm diameter and 55mm width.

There is an easy to print spool holder available here. Print it and fasten it on the right compartment of the printer, using an M3 screw, like this:

If your spool is wider than 55mm you have to add a spoolholder like this one made by Imarin.

Or choose one from Thingiverse like this or this...

To see how to load or unload the filament on your FABtotum, look here. ### Needs LINK ###

Clone this wiki locally
You can’t perform that action at this time.