Skip to content
An Arduino Leonardo shield to simplify the wiring of SFX-100 serial port connectors
Branch: master
Clone or download

Latest commit

Fetching latest commit…
Cannot retrieve the latest commit at this time.

Files

Permalink
Type Name Latest commit message Commit time
Failed to load latest commit information.
Group Buy Edition
Prototype Edition Housekeeping update Apr 24, 2019
LICENSE Update LICENSE Mar 24, 2019
README.md

README.md

SFX-100-Breakout-Board

An Arduino Leonardo shield to simplify the wiring of SFX-100 serial port connectors

For more information about the SFX-100 project, please visit: https://opensfx.com/

The "Group Buy Edition" is the latest and greatest.

The prototype works fine and uses the RJ45 connector for the E-stop instead of a screw terminal.

Releases

v1.35 April 24, 2019 A small modification to allow support for external power supplies higher than +5v. Not really necessary for our use case as powering by USB works fine and is typical for this application. But just in case someone out there does it differently for some reason. :)

======== v1.34 April 6, 2019 Group buy edition

This is the version of the board that was manufactured for the Group Buy.

  • Replaced the modular jack with a screw terminal connector for simplicity and cost reduction.

  • Removed JP1. You can shunt the screw terminal to test.

  • DB25 connectors are now more symmetrical on the board for a cleaner design

  • Board traces simplified and vias eliminated.

  • Trace thickness increased

  • Added additional holes for M3 mounting

  • Updated enclosure

======== v1.32 March 23, 2019 Intial public release

J1 is a modular connector for running an Ethernet cable to your e-stop. You need to connect the wires from pins 1 and 8 to your e-stop switch.

If you are not using an e-stop, you must install a shunt jumper across JP1 to enable the circuit.

You can’t perform that action at this time.