Flylink HD & Flylink AV make TX and RX connection

RAKwireless edited this page Aug 1, 2017 · 1 revision

This document is only using for Flylink HD and Flylink AV .

  • Flylink HD : RAK566(TX) and RA554(RX). Flylink AV : RAK553(TX) and RAK554(RX).
  • RAK5610 is same with RAK554 including firmware and Hardware.

1 RAK554 Dip switch definition

RAK554 Dip switch definition
There are 6 group Dial-up in the module . ON direction is showing low-level ,marked as 0. When The Dial-up is on the opposite direcetion ,that is showing high-level,marked as 1 . The dial-up flag order is 1-6,marked as sw1-6. The function definition is followed :

Sw6 Sw5 Band Channel Band
1 1 4 149 5745
1 0 1 48 5240
0 1 1 36 5180
0 0 4 165 5825

The default band is Band4. That is to say channel 149. Sw1 is using for WPS function . If you want to use this function , you need do the following steps.

  • Step1 : Whatever the SW1 level , set SW1 into low-level more than 1 second .
  • Step2 : Then Set SW1 into high-level .
  • Step3 : The Wifi light will blink.that is showing you have step into the WPS mode.

2 Make new Pair

2.1 Transmitter(STA): RAK566.

  • Step1 : Power on RAK566 waiting the board blink or lighting more than 10 seconds .
  • Step2 : Power on RAK554(RX) and waiting for blue LED turn on . Toggle Receiver’s DIP switch PIN1 to Low-Level more than 1 second and then Toggle to High-Level .The blue LED will be quick flashing. The Receiver have run into WPS Pair mode .
  • Step3 : Press the button in the red circle 3 seconds and leave . the blue LED will be quick flashing. The Receiver have run into WPS Pair mode . If not ,please try again . image
  • Step4 : Waiting for the Transmitter blue LED turn on more then 10 seconds. That means the configuration have completed .

2.2 Transmitter(STA): RAK553.

  • Step1 : Power on RAK553 waiting the board blink or lighting more than 10 seconds .
  • Step2 : Power on RAK554(RX) and waiting for blue LED turn on . Toggle Receiver’s DIP switch PIN1 to Low-Level more than 1 second and then Toggle to High-Level .The blue LED will be quick flashing. The Receiver have run into WPS Pair mode . image
  • Step3 : Same operation with Step2 on the Receiver .
  • Step4 : Waiting for the Transmitter blue LED turn on more then 10 seconds. That means the configuration have completed .
You can’t perform that action at this time.
You signed in with another tab or window. Reload to refresh your session. You signed out in another tab or window. Reload to refresh your session.
Press h to open a hovercard with more details.