Skip to content

Board: MSB 430H

Jose Alamos edited this page Aug 9, 2018 · 3 revisions

WARNING: This entry will be deprecated. All content has been moved to


ScatterWeb MSB-430H


MCU TI MSP430F1612
Family MSP430
Vendor Texas Instruments
Package 64 QFN
Flash 55Kb
Frequency 8MHz
FPU no
Timers 2 (2x 16bit)
ADCs 1x 8 channel 12-bit
SPIs 2
I2Cs 1
Vcc 2.0V - 3.6V
Datasheet / Reference Manual Datasheet
User Guide User Guide


RF Chip Texas Instruments® CC1100
Frequency Band 300-348MHz, 400-464 MHz, and 800-928 MHz
Standard compliance DASH7 compliant
Receive Sensitivity -94dBm typ
Transfer Rate 500kBaud
RF Power -30dBm ~ 10dBm
Current Draw RX: 14.4mA TX: 16.9mA Sleep mode: 400nA
RF Power Supply 2.1V ~ 3.6V
Antenna Dipole Antenna / PCB Antenna
Datasheet Datasheet

Flashing RIOT

Flashing RIOT on the MSB-430H is quite straight forward, just connect your board using a JTAG adapter (either the original one from TI or an Olimex version) to your host computer and type:

make flash

This should take care of everything!

Using the shell

The shell is using the UART interface of the MSB-430H at 115200 baud. You need a 3.3V TTL serial cable. For USB connections you could use a FTDI connector

More information

FU Berlin info page on the MSB-430H

Clone this wiki locally
You can’t perform that action at this time.