Skip to content

Board: Nucleo F303

Jose Alamos edited this page Aug 9, 2018 · 4 revisions

WARNING: This entry will be deprecated. All content has been moved to doc.riot-os.org

Overview

The Nucleo-F303 is a board from ST's Nucleo family supporting a ARM Cortex-M4 STM32F303RE microcontroller with 64Kb of RAM and 512Kb of ROM.

Hardware

nucleo image nucleo-f303 pinout

MCU

MCU STM32F303RE
Family ARM Cortex-M4
Vendor ST Microelectronics
RAM 64Kb
Flash 512Kb
Frequency up to 72MHz)
FPU yes
Timers 14 (13x 16-bit, 1x 32-bit [TIM2])
ADCs 4x 12-bit
UARTs 5
SPIs 4
I2Cs 3
RTC 1
Vcc 2.0V - 3.6V
Datasheet Datasheet
Reference Manual Reference Manual
Programming Manual Programming Manual
Board Manual Board Manual

Implementation Status

Device ID Supported Comments
MCU STM32F303RE partly Energy saving modes not fully utilized
Low-level driver GPIO yes
PWM one PWM
UART three UART
I2C two I2C
SPI two SPI
USB no
Timer one 32 timer

Flashing the device

The ST Nucleo-F303RE board includes an on-board ST-LINK V2 programmer. The easiest way to program the board is to use OpenOCD. Once you have installed OpenOCD (look here for installation instructions), you can flash the board simply by typing.

make flash

and debug via GDB by simply typing

make debug

Supported Toolchains

For using the ST Nucleo-F303RE board we strongly recommend the usage of the GNU Tools for ARM Embedded Processors toolchain.

Clone this wiki locally
You can’t perform that action at this time.