Skip to content

Board: Nucleo F411

Jose Alamos edited this page Aug 9, 2018 · 4 revisions

WARNING: This entry will be deprecated. All content has been moved to doc.riot-os.org

Overview

The Nucleo-F411 is a board from ST's Nucleo family supporting a ARM Cortex-M4 STM32F411RE microcontroller with 128Kb of SRAM and 512Kb of ROM Flash.

Hardware

Nucleo64 F401

MCU

MCU STM32F411RE
Family ARM Cortex-M4
Vendor ST Microelectronics
RAM 128Kb
Flash 512Kb
Frequency up to 100MHz
FPU yes
Timers 11 (2x watchdog, 1 SysTick, 6x 16-bit, 2x 32-bit [TIM2])
ADCs 1x 12-bit
UARTs 3
SPIs 5
I2Cs 3
RTC 1
Vcc 2.0V - 3.6V
Datasheet Datasheet
Reference Manual Reference Manual
Programming Manual Programming Manual
Board Manual Board Manual

Implementation Status

Device ID Supported Comments
MCU STM32F411RE partly Energy saving modes not fully utilized
Low-level driver GPIO yes
PWM yes (7 pins available))
UART 3 UARTs USART2 via STLink/USB or D0(RX)/D1(TX), USART1 on PA10(RX)/PA9(TX) and USART6 on PA12(RX)/PA11(TX)
I2C 1 I2C
SPI 1 SPI
USB no
Timer 1 32 bit timer (TIM5)

Flashing the device

The ST Nucleo-F411RE board includes an on-board ST-LINK V2-1 programmer. The easiest way to program the board is to use OpenOCD. Once you have installed OpenOCD (look here for installation instructions), you can flash the board simply by typing

make BOARD=nucleo-f411 flash

and debug via GDB by simply typing

make BOARD=nucleo-f411 debug

Supported Toolchains

For using the ST Nucleo-F411 board we strongly recommend the usage of the GNU Tools for ARM Embedded Processors toolchain.

Clone this wiki locally
You can’t perform that action at this time.