Skip to content

Board: Nucleo144 F429

Jose Alamos edited this page Aug 9, 2018 · 3 revisions

WARNING: This entry will be deprecated. All content has been moved to doc.riot-os.org

Overview

Not yet available upstream, see PR 6594

The Nucleo144-F429 is a board from ST's Nucleo family supporting a ARM Cortex-M4 STM32F429ZI microcontroller with 128Kb of SRAM and 1Mb of ROM Flash.

Hardware

Nucleo144 F429

MCU

MCU STM32F429ZI
Family ARM Cortex-M4
Vendor ST Microelectronics
RAM 256Kb
Flash 2Mb
Frequency up to 180MHz
FPU yes
Timers 17 (2x watchdog, 1 SysTick, 12x 16-bit, 2x 32-bit)
ADCs 3x 12-bit
UARTs 8
SPIs 6
I2Cs 3
RTC 1
Vcc 2.0V - 3.6V
Datasheet Datasheet
Reference Manual Reference Manual
Programming Manual Programming Manual
Board Manual Board Manual

Implementation Status

Device ID Supported Comments
MCU STM32F429ZI partly Energy saving modes not fully utilized
Low-level driver GPIO yes
PWM yes (9 pins available)
UART 2 UARTs USART3 via STLink/USB or D0(RX)/D1(TX), USART2 on PA3(RX)/PA2(TX) and USART1 on PA10(RX)/PA9(TX)
I2C 1 I2C
SPI 1 SPI
USB no
Timer 1 32 bit timer

Flashing the device

The ST Nucleo-F429ZI board includes an on-board ST-LINK V2-1 programmer. The easiest way to program the board is to use OpenOCD. Once you have installed OpenOCD (look here for installation instructions), you can flash the board simply by typing

make BOARD=nucleo144-f429 flash

and debug via GDB by simply typing

make BOARD=nucleo144-f429 debug

Supported Toolchains

For using the ST Nucleo144-F429 board we strongly recommend the usage of the GNU Tools for ARM Embedded Processors toolchain.

Clone this wiki locally
You can’t perform that action at this time.