Skip to content
Branch: master
Find file History
Fetching latest commit…
Cannot retrieve the latest commit at this time.
Type Name Latest commit message Commit time
Failed to load latest commit information.

8 Spout Dispenser from Donald Bell

Hello Drinkbot: 8 tube dispenser Hello Drinkbot: 8 tube dispenser installed

Notes on spout design.

This 8-tube design was modified by Donald Bell from a design shared on Thingiverse by dwmartin805 that accommodates 15 tubes.

Like the original the holes are designed to fit 3/16" ID polyethylene barbed tube fittings (McMaster 2808K105) that loosely seat into each hole and can be glued in place for a more permanent design. Being able to remove them makes them a little easier to clean, though.

Because of the initial design of my cocktail robot, I built in a slight angle to where it attaches. I imagine most people will want to throw this into their CAD software and have it attach at a right angle.

I printed mine in PLA with 10% infill and it's worked fine for my prototype so far, especially since it doesn't take any weight and really just organizes the tubes.

You can’t perform that action at this time.