3D printable rack posts with square holes for a Majestic EX 70-inch TV stand (Standout Designs).
- Cabinet dimensions (mm): 500 (W) x 460 (H) x 538 (D)
- Holes front offset: 112
- Holes rear offset: 102
- Top corner clearance with screw: 4.95
- Door width: 20
- Center of square hole distance: 465
TODO: Apply .05" fillets to corners.
TODO: Increase to 3 mm.
304 Stainless Steel (A240 TP304 2B) 14 Gauge (1.981 mm)
Proto-Stock Matt Black, Low Gloss, Smooth Hybrid
https://www.protocase.com/resources/bend-radius.php
| Category | Thickness | Minimum Bend | Bend Radius |
|---|---|---|---|
| Stainless Steel | 14 Gauge (1.981 mm) | 6.98 mm | 1.9 mm |
TODO: Derive k-factor from changed bend radius in eDrawing file sent by Protocase for v0.1.
- 0.440
This is for a Monoprice Maker Select 3D Printer v2 configured as a Prusa i3 printer in Cura.
- Profile: 0.2
- Infill: 20%
- Infill Pattern: Octet
- Build Plate Adhesion: Skirt
- Skirt Distance: 6 mm
- Support Placement: Touching Buildplate
- Support Overhang Angle: 50
- Support Horizontal Expansion: 2
- Add support blocker to the rack holes
This section is to determine if the depth of the rack is sufficient in the short term.
| U | Current | Future L | Future R |
|---|---|---|---|
| 1 | Patch Panel | Patch Panel | Patch Panel |
| 2 | Switch | Switch | Switch |
| 3 | pfSense + RPi | pfSense + RPi | |
| 4 | SAN + Worker | SAN + Worker | |
| 5 | SAN + Worker | SAN + Worker | |
| 6 | pfSense + FS | GPU + Worker | |
| 7 | pfSense + FS | GPU + Worker | |
| 8 | Drawer | Drawer | |
| 9 | UPS | UPS | UPS |
| 10 | UPS | UPS | UPS |
- Posts (inner): 461 mm
- Protocase Rails (C2907-18): 457 mm
- Travla Rails: 2 inches too long, will sit on shelf
- Drawer: 348 mm
- UPS: No depth because the rails won't fit. Will sit on the bottom.