Download the software

yichone edited this page Dec 12, 2016 · 4 revisions

(1) Download the compatible-Arduino software in the link:

http://en.doit.am/espduino.php, or

https://github.com/esp8266/Arduino/

and install it.

(2) Install the CH340 chip driver by the following choices.

Widowns & MAC

http://bbs.smartarduino.com/showthread.php?tid=2038

Ubuntu

https://github.com/esp8266/Arduino%20for%20Ubuntu

(3) After installation of Arduino and CH340 driver. Open the Arduino IDE, and choose the development board type " ESPDuino (ESP-13 module) ", as shown in the following Figure.

Then, you will see the setting information.

Note that, if you get the new version ESPduino (order it after Sep. 30, 2016), please further confirm whether the "Reset Method" is "ESPduino-V2" (which is also the default setting); if you get the old version (order it before Sep. 30, 2016), please choose the "Reset Method" is "ESPduino-V1".

(4) Test the Arduino IDE

After building the Arduino IDE, we should test whether the Arduino IDE for ESPduino board is normal by a example, the Blink, which is provided by the standard Arduino IDE, as shown in the following Figure.

If it is successful, then the Arduino IDE for ESPduino IDE is ok.

Clone this wiki locally
You can’t perform that action at this time.
You signed in with another tab or window. Reload to refresh your session. You signed out in another tab or window. Reload to refresh your session.
Press h to open a hovercard with more details.