DS1820 Temperature sensor

MakeCode for the DS1820 / DS18B20 Temperature sensor.

Hardware Setup

1. Connect the appropriate pins (GND, V, S) to the micro:bit.
2. Connect a resistor (10kΩ can do) across the V and S pins to pull the signal high. (The micro:bit's internal pull-up doesn't work, for some reason.)

Blocks

1. Initialise with the connect temperature probe block in on start.
2. Get your reading from the temperature variable.
3. Note that the temperature is 10x the actual temperature, in degrees celsius. 30.5°C would hence show 305.

Supported targets

• for PXT/microbit