Shikra (http://int3.cc/products/the-shikra) programming utility
Switch branches/tags
Nothing to show
Clone or download
Fetching latest commit…
Cannot retrieve the latest commit at this time.
Permalink
Failed to load latest commit information.
README.md
shikra.py

README.md

Shikra EEPROM Programming

Requirements

  1. Install Libusb: sudo apt-get install libusb-dev on linux. OSX can skip this step.
  2. Install pyusb python libusb bindings: sudo pip install pyusb
  3. Run Shikra programming utility: sudo ./shikra.py Root access is needed to be able to Read and Write to the Shikra USB Device.

Using LED programming methods

The Shikra programming utility allows users to enable the Shikra LED under different configurations. These methods are called set_led_* Warning: This may not work with older Shikra devices.

  1. Run utility: sudo ./shikra.py
  2. Find attached Shikra device with find_shikra
  3. Set LED configuration with set_led_*
  4. Write config to Shikra EEPROM with write_config

Utility Output

[+] Welcome to the SHIKRA programming utility by XIPITER.

  ###### ###  ##  ###  ###  ##  ######      ####
 ###  ## ###  ##  ###  ### ##   ###  ##    #####
 ####    ###  ##  ###  #####    ###  ##   ## ###
  #####  #######  ###  #####    ######   ##  ###
    #### ###  ##  ###  ### ##   ### ##  ########
 ##  ### ###  ##  ###  ###  ##  ###  ## ##   ###
  #####  ###  ##  ###  ###  ##  ###  ## ##   ###

shikra> help

Documented commands (type help <topic>):
========================================
find_shikra  help

Undocumented commands:
======================
EOF  exit

shikra> find_shikra
[+] Looking for Shikra...
[+] Shikra device found.
shikra programming> help

Documented commands (type help <topic>):
========================================
backup         help                 set_led_off  set_led_tx    zero
dump           print_config         set_led_on   set_led_txrx
factory_reset  restore_from_backup  set_led_rx   write_config

Undocumented commands:
======================
EOF  exit

shikra programming>