something got broken in 1.1.1 ,
when doing bridges , slic3r puts way too much flow and bridges sag and fall down.
bridge flow ratio setting give no effect at all (is ignored)
1.0.1 works fine.
here are gcodes generated by both slic3rs :
http://188.8.131.52/tmp/slic3r/przegub2.gcode - experimental version
http://184.108.40.206/tmp/slic3r/przegub3.gcode - 1.0.1 stable
source stl is :
What about 1.1.2?
works fine in 1.1.2 , thanks! :)
bug reappears in 1.1.3 .
I just tried, and bridge flow ratio has a visible effect on the output.
What's the evidence showing this bug reappeared?
yeah, tested bit harder and it seems it's tweakable, just the flowrate itself changed significantly vs 1.0.1 so i got fooled . sorry for wasting your time.
tried again with testcase :
and unfortunatelly bug IS there.
1.0.1 : ; filament used = 923.4mm (6.4cm3)
1.1.3 with bridge flow ratio 1 : ; filament used = 1011.4mm (7.0cm3)
1.1.3 with bridge flow ratio 0.5 : ; filament used = 1011.4mm (7.0cm3)
http://220.127.116.11/tmp/slic3r/Bridge_test.gcode (1.1.3, bridge flow ratio 1)
http://18.104.22.168/tmp/slic3r/Bridge_test_05.gcode (1.1.3 bridge flow ratio 0.5)
Fixed regression causing bridge flow to be incorrect when a manual de…
…fault extrusion width was specified. Includes several regression tests. #2027
Oh, ugly regression. Bridge flow was incorrect when a default extrusion width was specified (like in your case). I added several regression tests on this now. Thank you for reporting.