Version 1.2.1 impacts print bed on first layer #2349

Closed
atleberg opened this Issue Nov 9, 2014 · 4 comments

Projects

None yet

2 participants

@atleberg
atleberg commented Nov 9, 2014

When testing version 1.2.1 the print head crashes into the print bed when using Z-offset. I've got mine set at 3.32mm. First layer is set to 0.4mm, but layer hight is 0.2mm. Since my PrintInZ plate is higher than that it's good I have springs underneath ;)

It goes straight down and then up again before doing the first XY move. This can be seen in the g-code:
G1 Z0.200 F9600.000
G1 Z3.720 F9600.000

The same STL file slices as expected in 1.1.7

@alexrj
Owner
alexrj commented Nov 9, 2014

@atleberg, can you provide full configuration? File -> Export config

@alexrj alexrj added this to the 1.2.2 milestone Nov 9, 2014
@alexrj alexrj added a commit that referenced this issue Nov 9, 2014
@alexrj Bugfix: a move below z_offset was performed when retract_lift was ena…
…bled and lift amount was less than z_offset. Includes regression test. #2349
6135a9f
@alexrj
Owner
alexrj commented Nov 9, 2014

I found one case where this could happen, it was not covered by a unit test. I now fixed it and added a regression test.

However, I still ask you to provide your configuration so that I can check whether your case is different or this fix is enough. Thank you.

@alexrj
Owner
alexrj commented Nov 9, 2014

Yes, I confirm this case is fixed.

Workaround until I release 1.2.2 is to disable lift on retraction.

@alexrj alexrj closed this Nov 9, 2014
@alexrj alexrj added Fixed and removed Needs more info labels Nov 9, 2014
Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment