Skip to content

Home

Jump to bottom
Andrey Klimov edited this page May 5, 2019 · 8 revisions

Table of content

Welcome to the LightHub wiki! LightHub is Flexible, Arduino based SmartHome controller

It allow to connect together:

  • Contact sensors (switches, buttons etc)
  • 1-Wire temperature sensors (up to 20 on single bus)
  • Standard nonexpensive Relay board with TTL inputs, (like this) to control AC powered lamps, floor heaters, boilers etc
  • Standard LED and AC DMX-512 dimmer boards
  • Modbus RTU devices (Currently, are deployed two types of Modbus devices: AC Dimmer and Ventilation set (Based on Vacon 10 controller)
  • Simple DMX wall sensor panel

Where is possible both, to configure local control/mapping between inputs and outputs (light, floor heating thermostats) and remote control from Openhab or Openhab2 Smarthome software

Scalability is virtually unlimited: Setup so many controllers you needed in most convenient places of your house - MQTT broker will allow controllers communicate each other and with Openhab and propagate commands across network

This Wiki is outdated - pls use https://www.lazyhome.ru/dokuwiki/doku.php?id=start

Features Compiling and flashing Configuring

Clone this wiki locally