Skip to content
New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

RPi 3B+ camera not detected #1480

Open
gmccauley opened this issue Apr 10, 2018 · 6 comments

Comments

Projects
None yet
5 participants
@gmccauley
Copy link

commented Apr 10, 2018

Just got another Pi 3B+ today and figured I'd give this a shot. Installed pre-release 20180401 of MotionEyeOS, but my official Noir v2.1 is not being detected. I know the camera and cable is good, because it works on another Pi running OctoPi.

Looks like the Pi recognizes the camera:
[root@meye1 ~]# vcgencmd get_camera
supported=1 detected=1

Tried running raspistill and get the below:
[root@meye1 ~]# raspistill -k
mmal: mmal_vc_component_enable: failed to enable component: ENOSPC
mmal: camera component couldn't be enabled
mmal: main: Failed to create camera component
mmal: Failed to run camera app. Please check for firmware updates

Any suggestions?

@ccrisan

This comment has been minimized.

Copy link
Owner

commented Apr 10, 2018

  1. What does vcgencmd get_mem gpu say?
  2. Does it work with Raspbian on the same setup?
@gmccauley

This comment has been minimized.

Copy link
Author

commented Apr 11, 2018

[root@meye1 ~]# vcgencmd get_mem gpu
gpu=256M

I did not try raspian yet.

@rodo2020

This comment has been minimized.

Copy link

commented Apr 14, 2018

I have the same error with Pi 3 B.

@Bandi017

This comment has been minimized.

Copy link

commented May 2, 2018

same issue with a zero W

in my case it works now ... problem was that i was using a wrong ip when running the script....

@ccrisan

This comment has been minimized.

Copy link
Owner

commented May 3, 2018

@rodo2020

  1. Have you tweaked anything or it simply doesn't work at all with the default motionEyeOS settings?
  2. Are you sure you have plugged it in the correct socket?
  3. Can you try Raspbian on the very same setup and see if the camera actually works?
@llamafilm

This comment has been minimized.

Copy link

commented Jun 16, 2018

Same issue here too on a Pi Zero W. Do you have any advice on how to dual-boot Raspbian and MotionEyeOS on a single SD card so I can test the hardware?

Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment
You can’t perform that action at this time.