Skip to content
Open source FPP PB16 Pixel Controller
Branch: master
Clone or download
Fetching latest commit…
Cannot retrieve the latest commit at this time.
Permalink
Type Name Latest commit message Commit time
Failed to load latest commit information.
Kicad
FPP PB16 Pixel Controller Manual and Assembly Guide.odt
FPP PB16 Pixel Controller Manual and Assembly Guide.pdf
LICENSE
PB16-eeprom.bin
PB16_Bom.ods
PB_16.png
PB_16_angle.png
PB_16_labels.png
PB_16_rev_C.jpg
README.md
gerbers.zip

README.md

Copyright and Disclaimer

Copyright: Scott Hanson

This documentation describes Open Hardware and is licensed under the CERN OHL v. 1.2.

You may redistribute and modify this documentation under the terms of the CERN OHL v.1.2. (http://ohwr.org/cernohl). This documentation is distributed WITHOUT ANY EXPRESS OR IMPLIED WARRANTY, INCLUDING OF MERCHANTABILITY, SATISFACTORY QUALITY AND FITNESS FOR A PARTICULAR PURPOSE. Please see the CERN OHL v.1.2 for applicable conditions

PB 16

The PB16 Pixel Controller is designed as an open source DIY hobbyist controller. A Pocketbeagle running FPP drives the 16 pixel ports and 2 serial ports. The design was made with all through hole components for easy assembly by most users. It is designed to be modular and support many use cases. It runs a full Linux operating system with ethernet, WIFI and audio supported over the USB port. It can run in standalone, or be used with other controllers/devices. It is 140mm (5’) wide by 103mm(4’) tall. The controllers small form factor and simplistic design are intended to limit overall cost. All the design files are open source and available on github. Open source applications were used to create this controller. KiCad was used for the PCB design, and LibreOffice for the documentaion.

Manual

Part BOM

Image of Rev C Controller

You can’t perform that action at this time.