Skip to content

Badge Assembly Instructions

kexela edited this page Aug 8, 2018 · 1 revision

DCZIA Shitty Add on badge (Shape of zia, says DCZIA 2018 in silver on the badge)

  1. Package contents:

    • 1 - 4 pin header connector (black)
    • 1 - Badge PCB
    • 2 - 330-ohm Resistors (SMD)
    • 2 - LED Diodes (Reverse mount, SMD, white)
  2. Solder SMD Resistor 2a) Locate R6 on silkscreen, solder one 330-ohm SMD resistor between solder pads to the right of the R6 label. 2b) Locate R7 on silkscreen, solder one 330-ohm SMD resistor between solder pads above the R7 label.

  3. Solder LEDs 3a) Locate D1 on silkscreen, solder one LED between solder pads above the D1 label. Make sure the LED's notch is mounted towards the 4 holes for the 4 pin connector. 3b) Locate D2 on silkscreen, solder one LED between solder pads above the D2 label. Make sure the LED's notch is mounted towards the 4 holes for the 4 pin connector.

  4. Solder 4 pin connector / header Place black plastic on the DCZIA 2018 labeled side of the PCB. Solder 4 connections on open yellow face of the PCB.

NOTE: Please make sure that GND/ VCC are aligned to the proper connectors when plugging into an external board.

POST-CON: More complex design available for expansion post-con. If wanted, there is an alternative design that includes a Microcontroller. Example parts list to be ordered will be posted, along with some simple PWM code.

Clone this wiki locally
You can’t perform that action at this time.