dcrd-continuous fuzzing

Install the following prerequisites

• Go 1.13 or 1.14

  Installation instructions can be found here: https://golang.org/doc/install. Ensure Go was installed properly and is a supported version:

  $ go version
  $ go env GOROOT GOPATH

  NOTE: GOROOT and GOPATH must not be on the same path. Since Go 1.8 (2016), GOROOT and GOPATH are set automatically, and you do not need to change them. However, you still need to add $GOPATH/bin to your PATH in order to run binaries installed by go get and go install (On Windows, this happens automatically).

  Unix example -- add these lines to .profile:

  PATH="$PATH:/usr/local/go/bin"  # main Go binaries ($GOROOT/bin)
  PATH="$PATH:$HOME/go/bin"       # installed Go projects ($GOPATH/bin)
  

• Gofuzz

  go get -u github.com/dvyukov/go-fuzz/go-fuzz github.com/dvyukov/go-fuzz/go-fuzz-build

• Docker (Needed for default docker version)

  Install: https://docs.docker.com/engine/install/.

  Post Install setup docker group https://docs.docker.com/engine/install/linux-postinstall/#manage-docker-as-a-non-root-user.

To run

chmod +x run.sh

./run.sh 10m

The above command runs each fuzzer (currently eleven) for 10 minutes. It is recommended to not make this value too low.

On first run the script will use docker to generate the go-fuzz bins and place them in the fuzzbins folder.

Once one full loop of fuzzing is done the script will check dcrd master for any changes and will update the bins if needed. It also outputs alerts for any crashes found.

corpus and crashes can be found in the relative folder inside output/

There is also a dockerless version

chmod +x build.sh
chmod +x dockerless_run.sh

./dockerless_run.sh 10m

Libfuzzer

To run the libfuzzer code just add lib_ to the above commands.

Credits

Uses fuzzing code/logic from https://github.com/guidovranken/dcrd-fuzzers