Free Libre Open-Source/-Hardware JTAG/UART Adapter based on the FT2232H chip.
The hardware is licensed under Creative Commons Share Alike By Attribution 3.0 (CC-BY-SA 3.0)
Copyright 2009-2010 Piotr Esden-Tempski
UART connector adapter side:
Pin No. | Name |
---|---|
1 | +3.3V |
2 | TXD |
3 | RXD |
4 | GND |
The numbering of the connector is from left to right when looking from the edge of the board at the pins of the header.
Hardware design file notes:
All designs up until version 1.0 of Floss-JTAG were designed in Cadsoft EAGLE. To view the files you will need to install EAGLE. Most of the designs are 4-layer; this means that you will need a paid version of the software to edit the inner layers of the board.