You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Tested on 2.6.5, although possibly exists on earlier versions of firmware as well.
If you control the servo using the SP command, it will always work fine. If the power timer shuts off power to pin B1, then an SP command will always apply power again before starting the move.
However, if power has been shut off to the servo, the S2 command will NOT turn power back on before starting the move.
The text was updated successfully, but these errors were encountered:
Tested on 2.6.5, although possibly exists on earlier versions of firmware as well.
If you control the servo using the SP command, it will always work fine. If the power timer shuts off power to pin B1, then an SP command will always apply power again before starting the move.
However, if power has been shut off to the servo, the S2 command will NOT turn power back on before starting the move.
The text was updated successfully, but these errors were encountered: