Find file History
fail0verflow
fail0verflow Initial commit
Latest commit ace813d Apr 23, 2018
Permalink
Type Name Latest commit message Commit time
..
Failed to load latest commit information.
README.md Initial commit Apr 23, 2018
rcm-jig.jpg Initial commit Apr 23, 2018
rcm-jig.scad Initial commit Apr 23, 2018
rcm-jig.stl Initial commit Apr 23, 2018

README.md

3D-printable RCM jig for the Switch

This little jig will let you enter RCM mode without having to sacrifice a Joy-Con or hold a piece of wire. You will need to break up a Micro USB connector to get at the pin contact wafer inside, remove all but pins 1 and 4 (which will contact pins 7 and 10 on the Switch respectively), short them together at the rear, then insert the wafer into the 3D printed jig. Trim it to fit and superglue it in place, then verify that the placement looks good.

RCM jig photo