Boards
- Supports following terminal types: ANSI, VTxxx, ADM 3A, ADM 31, Hazelttine 1500, Osborne, Kaypro ant VT52.
- USA, English, German, Italian, Spanish, French, Belgian and Norwegian keyboard layouts.
- TTL (5V) serial port.
- RS232 serial port (TX, RX, RTS, CTS)
- Two PS/2 ports for Keyboard and Mouse.
- One VGA output, up to 64 colors.
- One audio out (line level, not amplified).
- Power-only USB port: can power a Z80 board, like the MBC2.
- Bottom 8 PINs connector, with RX, TX, GND, 5V signals (compatible with MBC2-Z80 board).
- Upper 8 PINs connector 6 GPIOs (3.3V volts).
- Preprogrammed with FabGL Serial Terminal, but reprogrammable with any compatible FabGL program (requires Programmer - see Add-ons)
- WROVER-E based with 16MB Flash and 4MB PSRAM
- VGA video output
- Audio output (line level)
- PS/2 Mouse and Keyboard inputs
- Micro SD socket
- I/O extender with 16 GPIOs (3.3V max voltage, MCP23S17 based)
- firmware upload up to 460800 bps (uses CH340C USB-Serial chip)
Supports all FabGL applications, including the PC Emulator: now you can program your I/O pins using GWBasic or QBASIC under MSDOS!!
Compatible with LEDs and Buttons board
Purchasing this board you support the FabGL project!
Examples with pluggable LEDs and Buttons board:
This board has two PS/2 ports (mouse and keyboard), a VGA out with 64 colours, an Audio out (line and speaker) and an additional UART. Pins configuration is the same of FabGL default.
board for ESP32-WROVER-B and a binding for mruby
