High oil pressure after engine start

[cptnuss-ops]

Aircraft Version

Experimental

Build info

{
  "built": "2021-10-12T04:16:01+00:00",
  "ref": "experimental",
  "sha": "17e397669a652a865a4bedc68ae8a6fea75d59b3",
  "actor": "2hwk",
  "event_name": "manual"
}

Describe the bug

After the engine start, the oil pressure starts rising to around 280 psi and the displayed value starts blinking. When applying thrust, the pressure keeps climbing to 400 psi at 80% N1 on the ground. No abnormalities can be observed regarding other parameters of the engine. There's no ECAM message displayed for this failure.

Expected behavior

Engine oil pressure keeps within the operating limits or if a failure is intended, the ECAM displays a correct message.

Steps to reproduce

1. Power-up the airplane
2. Supplying the plane with high-pressure air
3. Start engine of choice, doesn't matter because the bug appears on both engines.
4. open ENG page on ECAM to observe oil pressure

References (optional)

No response

Additional info (optional)

Discord Username (optional)

cpt.nuss#6582

[Venorcis]

AFAIK this has been happening on the dev version for ages as well

[BlueberryKing]

This is a known issue. There is a tracking issue for this in #3117

[derl30n]

the engines secondary parameters such as oil quantality, pressure and temperature are not yet modeled.