[Request] Allow Bed position to be set in gcode viewer

[thinkl33t]

My bed center is at [0,0], not the usual [100,100], which means the grid on the gcode viewer is off to one side. Not a major issue, but a config variable to set the bed's width, height, and 0 position would be very nice :)

[nophead]

Hi Bob,
My bed centre is in the middle as well but my gcode view is centred correctly in OctoPrint. I don't know why though as I can't find a setting for it.

[stv0g]

Having the same problem. 👍 Especially for Delta Robots where parts are centered around the origin coordinates [0,0].

[foosel]

@stv0g for delta robots you can just set the print bed to be circular, this will automatically make the origin be in the center. While you need the devel branch for that, this actually IS already possible.

This ticket is actually about an arbitrary center location for rectangular beds, which is NOT yet possible, not even in devel.

[stv0g]

Oh thanks @foosel So I will check out the devel branch :-)

[foosel]

THanks to work by @markwal, that's now available on devel. No arbitrary location on the printbed, but you can choose between "center" and "lowerleft" for rectangular beds. Circular beds are limited to "center" for now.