Glue section inconsistency

[helgoboss]

[QUOTE=7enz;2663134]@helgoboss

just reporting a small bug i picked up on...
may already have been sorted

if there is a value (value sequence) inside of incremental/normal on the glue section

this disables the toggle Target min/max from showing up, when you choose to change the mode selection(toggle/inc/norm)
whatever the previous value was in the value sequence(normal/incremental)
it seems to remain the same target Min/Max in the toggle(even though you cannot see it)

so effectively you need to remove the value inside of the Value sequence and then change to toggle at which point the min/max become available again, but with the previous value on the min/max that was previously set
instead of the default (min=0 max=100)[/QUOTE]