Switch branches/tags
Nothing to show
Commits on Feb 19, 2018
  1. Adapt to pstoedit 3.71

    hzeller committed Feb 19, 2018
Commits on Nov 19, 2017
Commits on Nov 1, 2017
Commits on Oct 30, 2017
  1. More via stitching between GND planes.

    hzeller committed Oct 30, 2017
    Mostly to heatsink ULN2003, but also in other places to reduce
Commits on Oct 29, 2017
  1. More cooling for ULN2003

    hzeller committed Oct 29, 2017
    o Connect unused pins to a GND copper plane for slightly better
      heat distribution (in any case, we are well within ratings
      of the chip; the sum of all currents is never more than 500mA).
  2. Connect USB output to SYS 5V

    hzeller committed Oct 29, 2017
    o SYS 5V has a cleaner switch-on transition than the raw DC/DC out.
Commits on Oct 24, 2017
Commits on Oct 8, 2017
  1. Remove unneccessary inner layers.

    hzeller committed Oct 8, 2017
    o There were inner layers left-over from basing this on the PocketBeagle.
      Just keep Top/Bottom.
    o Remove leftover text from inner layers.
  2. Update cape rendering.

    hzeller committed Oct 8, 2017
  3. Import all net names to PCB.

    hzeller committed Oct 8, 2017
Commits on Oct 5, 2017
  1. Improve silkscreen.

    hzeller committed Oct 5, 2017
    o Label signals directly on header for easier measurements.
    o Arrange partially obstructed component labels.
  2. Intermediate state: initial display and USB connector.

    hzeller committed Oct 5, 2017
    o Add flat flex connector to drive a simple SPI-based display.
    o Try to cram a vertial USB connector onto the board to be able
      to have a wifi dongle.
Commits on Oct 1, 2017
  1. Simplyfy photo diode sync input.

    hzeller committed Oct 1, 2017
    o The 74LVC14 inputs are sufficiently high impedance that we
      can directly connect the photo input.
    o Also: switch to JST PH 2mm connectors for laser output.
Commits on Sep 30, 2017
  1. Fix wrong connection to stepper connector.

    hzeller committed Sep 30, 2017
    o common is not the center tap, but Pin5
    o Also some more labelling (e.g. adding RX/TX)
  2. Move component labels for better readability.

    hzeller committed Sep 30, 2017
    Also add signal labels on the PocketBeagle header for easier testpoint
Commits on Sep 29, 2017
  1. Pocket Cape, pre-routing.

    hzeller committed Sep 29, 2017
Commits on Sep 28, 2017
  1. Start pocket-beagle cape.

    hzeller committed Sep 28, 2017
Commits on Sep 17, 2017
  1. o Prepare cone-mirror code.

    hzeller committed Sep 17, 2017