WARNING: (2016-02-09) This Fork highly is Experimental!!
- added possibility to write direct to a Legic Prime Tag (MIM256/1024) without using values from the 'BigBuffer' -> 'hf legic writeRaw '
- added possibility to decrease DCF values at address 0x05 & 0x06 on a Legic Prime Tag DCF-value will be pulled from the BigBuffer (address 0x05 & 0x06) so you have to load the data into the BigBuffer before with 'hf legic load <path/to/legic.dump>' & then write the DCF-Values (both at once) with 'hf legic write 0x05 0x02'
- added script legic.lua for display and edit Data of Legic-Prime Tags
Build Status Travis CI
The proxmark3 is a powerful general purpose RFID tool, the size of a deck of cards, designed to snoop, listen and emulate everything from Low Frequency (125kHz) to High Frequency (13.56MHz) tags.
This repository contains enough software, logic (for the FPGA), and design documentation for the hardware that you could, at least in theory, do something useful with a proxmark3.
This repository! https://github.com/Proxmark/proxmark3
The GitHub page http://proxmark.github.io/proxmark3/
The Forum http://www.proxmark.org/forum
The IRC chanel irc.freenode.org #proxmark3 -or- http://webchat.freenode.net/?channels=#proxmark3
The tools required to build or run the project will vary depending on your operating system. Please refer to the Wiki for details.
The Proxmark 3 is available for purchase (assembled and tested) from the following locations:
Most of the ultra-low-volume contract assemblers could put something like this together with a reasonable yield. A run of around a dozen units is probably cost-effective. The BOM includes (possibly- outdated) component pricing, and everything is available from Digikey and the usual distributors.
If you've never assembled a modern circuit board by hand, then this is not a good place to start. Some of the components (e.g. the crystals) must not be assembled with a soldering iron, and require hot air.
The schematics are included; the component values given are not necessarily correct for all situations, but it should be possible to do nearly anything you would want with appropriate population options.
The printed circuit board artwork is also available, as Gerbers and an Excellon drill file.
This program is free software; you can redistribute it and/or modify it under the terms of the GNU General Public License as published by the Free Software Foundation; either version 2 of the License, or (at your option) any later version.
This program is distributed in the hope that it will be useful, but WITHOUT ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for more details.
You should have received a copy of the GNU General Public License along with this program; if not, write to the Free Software Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA 02110-1301 USA
Jonathan Westhues user jwesthues, at host cq.cx
May 2007, Cambridge MA