Branch: master
Find file History
Fetching latest commit…
Cannot retrieve the latest commit at this time.
Permalink
Type Name Latest commit message Commit time
..
Failed to load latest commit information.
Bottom-for-STS-5-geiger-tube.stl
Cover for the SBT11 window.stl
Cover with paper filter insert for SBT11 window.stl
Cover with wider filter insert for SBT11 window.stl
Enclosure5bottom.stl
Enclosure5top.stl
P5_Top_for_sbt11.stl
P5_bottom_for_SBM20_with_accessible_battery_compartment.stl
P5_bottom_for_STS-5_with_accessible_battery_compartment.stl
P5_bottom_for_sbt11.stl
P5_bottom_for_sbt11_with_accessible_battery_compartment.stl
P5_bottom_for_sbt9.stl
P5_top_for_sbt9.stl
P5bottom-si29bg.stl
P5bottom-si29bg_with_accessible_battery_compartment.stl
P5top-si29bg.stl
README.txt
Top-For-SBM-20-Tube.stl
Top-for-STS-5-geiger-tube.stl
batterycompartmentcover.stl
plug_for_serial.stl

README.txt

There are .stl files of enclosure variants for use with different Geiger-Müller tubes.
The original ones Top-For-SBM-20-Tube.stl and Enclosure5bottom.stl are for use with SBM-20 (СБМ-20) tubes.
Other variants contain the name of the tube they are for (namely STS-5, SI29BG, SBT9 and SBT11/SBT11A). Two files (top and bottom) are needed but you can also print the plug_for_serial.stl . It is a plug for the SerialTTl connection openning if you have cut it open and need to have it plugged.



Suggested print settings for PLA:

0.4  	mm print-head
0.25 	mm resolution
100%  	in-fill ratio
2    	shells
50mm/s 	default printing speed (may depend on your PLA)
50℃  	heated bed
215℃	     print-head temperature (may depend on your PLA)
100%      fan speed
25%       support in-fill ratio

(for SBT-11 enclosure)
35%  	Support in-fill ratio
Line      Support type
0mm       Gap between the support and top layer
5         loops of brim at 0mm from the print
Touch Platfor Only - support


     	printing volume enclosed

no raft and no brim if you have a good adhesion (this way top panel prints smooth and requires no post processing. 

! However if you a struggling with adhesion - use all counter means possible as this is the prolonged part with sharp straight corners and especially if you have to print on cold bed without Buildtak surface and no printer volume enclosure you will most certainly have a curl at the corners.