NornsShieldCase
I wanted to make a 3d printable case for the Monome Norns shield without top panel screws.
Note: this is my first Fusion 360 design, and remains untested as I currently don't have a 3d printer to make one.
The case consists of two parts.
Hardware required: 4 m2.5 * 6 screws 2 M2.5 16mm hex standoffs 2 M2.5 threaded inserts
Construction as follows:
- Turn the top part of the case over, front facing you.
- Use a soldering iron to melt in the two M2.5 threaded inserts into the two front holes.
- Put the Norns Shield PCB in the top part and screw in the two M2.5 hex standoffs in the two back holes.
- Put in the RPi, connecting it to the Norns Shield PCB using the header*
- Turn over and put on the bottom part of the case and screw in the M2.5 screws to finish.
(* not sure if this will work with the ports extruding from the case, but there's a little wiggle room in the header of the RPi)
The case has built in supports/standoffs for the PCBs except for the standoff required between the shield and the RPi.
