Vim Arduino Ino
UPDATE: THIS PROJECT IS DEPRECATED
does not work with newer versions of the Arduino app. Thus, this tool will not work unless you install an older version of the Arduino app. If someone wants to contribute an update to Ino that supports newer versions of the app, they can submit a pull request to the current repo.As of now, the Arduino Ino command line tool
This script is based on Vim Arduino, but uses the [Ino][ino] command line utility instead of the Java Arduino compiler. It therefore runs in 64-bit environments and allows for compiling and deployment of Arduino (*.pde/*.ino) sketches directly from Vim.
The plugin is structured for use with Pathogen so installation should be easy, assuming you have Pathogen installed.
Ano must be installed on your computer for this plugin to work (Previously, Ino was used, but that repo is no longer maintained).
To install Ano, you can install from source using the instructions here or
npm install ano if you have npm installed.
If you plan on using this plugin with a board other than an Arduino Uno, you'll need to configure Ino to use that board by following the instructions found here.
Vim Arduino Ino can be run using the following keys:
<Leader>ac - Compile the current sketch.
<Leader>ad - Compile and deploy the current sketch.
<Leader>as - Open a serial port in
In order for the build to complete successfully, your project directory will need to be set up like a normal ino project. For more information on ino project setup, see here.
The default key mapping can be turned off by doing this in your
let g:vim_arduino_map_keys = 0
To open the serial monitor automatically after each deploy,
add this to your
let g:vim_arduino_auto_open_serial = 1
To change the command used to build and deploy :
let g:vim_arduino_ino_cmd = 'ano'