Permalink
Commits on Oct 22, 2000
  1. - made consist between tcp and udp in using mappedaddr

    - setsockopt(BIND_IPV6ONLY) now works
    sumikawa committed Oct 22, 2000
  2. * kame/sys/netinet6/in6_pcb.c (freebsd2/bsdi3):

      don't do anything special against IPv4 mapped address, as we don't
      support them.
    itojun committed Oct 22, 2000
  3. if tcp6/tcp4 are separate and we don't support IPv4 mapped address at…

    … all,
    
    pcb layer should do nothing special against IPv4 mapped address.
    (bsdi3/freebsd2)
    
    revealed by bindtest
    itojun committed Oct 22, 2000
  4. portability - sa_family_t is not too common

    itojun committed Oct 22, 2000
  5. document bsdi4 panic on multicast socket close

    itojun committed Oct 22, 2000
  6. show path MTU changes

    itojun committed Oct 22, 2000
  7. correct icmp6 pmtu change stat

    itojun committed Oct 22, 2000
Commits on Oct 21, 2000
  1. Initial revision

    sumikawa committed Oct 21, 2000
Commits on Oct 20, 2000
  1. correct manpage for -s.

    itojun committed Oct 20, 2000
  2. move unusual items to the bottom (NOTE: diff-friendly with past verbo…

    …se mode)
    itojun committed Oct 20, 2000
  3. whitespace

    itojun committed Oct 20, 2000
  4. $KAME$

    itojun committed Oct 20, 2000
  5. bindtest -s

    itojun committed Oct 20, 2000
Commits on Oct 19, 2000
  1. * openbsd: enable IPv6 PTMUD DoS prevention. validates TCP6/UDP6 PMTUD

      by existence of connected pcb.
    itojun committed Oct 19, 2000
  2. enable PMTUD DoS prevention for openbsd

    itojun committed Oct 19, 2000
  3. memcpy -> bcopy

    itojun committed Oct 19, 2000
  4. * ping6: by default, fragment packet into 1280 bytes (IPv6 minimum MTU).

      -m will suppress the behavior (send it as is, and obey path MTU
      discovery).
    itojun committed Oct 19, 2000
  5. * racoon:

    - check whether the initial contact is acceptable.
    when both ends are using "use" as the policy level, both ends initiate
    the phase 1 and send initial-contacts under each phase 1 SA.  In this
    case, each phase 1 SA will be banished by the another initial-contact.
    Simply calling getcontacted() is the solution to avoid the case.
    sakane committed Oct 19, 2000
  6. check whether the initial contact is acceptable.

    sakane committed Oct 19, 2000
  7. the direction was reverse.

    sakane committed Oct 19, 2000
  8. - fixed to compare the types of both end.

    - fixed to compare the subjectNames of both end.  don't compare them directly.
    sakane committed Oct 19, 2000
  9. changed pfs group in phase 2.

    sakane committed Oct 19, 2000
  10. 2000-10-19 JINMEI, Tatuya <jinmei@isl.rdc.toshiba.co.jp>

    	* kame/sys/netinet6/ip6_mroute.c (add_m6fc): made sure to reset
    	the outgoing interfaces list in all cases where a multicast
    	routing cache is created or updated.
    	In response to a report from Hoerdt Mickael
    	<hoerdt@clarinet.u-strasbg.fr>
    jinmei committed Oct 19, 2000
  11. in add_m6fc(), set interface list for all cases.

    in response to a report from Hoerdt Mickael.
    jinmei committed Oct 19, 2000
  12. TODO for PMTUD DoS prevention

    itojun committed Oct 19, 2000
  13. * sys/netinet6/icmp6.c: (netbsd only for now) try to prevent

      DoS attack using path MTU messages.  validate ICMPv6 too big messages
      using content of TCP/UDP connection table and/or IPsec SAs.
      framework by thorpej@netbsd.org.  sync with netbsd-current.
    itojun committed Oct 19, 2000
  14. blank lines

    itojun committed Oct 19, 2000
  15. PMTU DoS prevention. netbsd only.

    itojun committed Oct 19, 2000
  16. memcpy -> bcopy

    itojun committed Oct 19, 2000
Commits on Oct 18, 2000
  1. ICMPv6 too big DoS prevention. netbsd only.

    itojun committed Oct 18, 2000
  2. use {ah,esp}6_ctlinput for netbsd

    itojun committed Oct 18, 2000
  3. remove too much merge

    itojun committed Oct 18, 2000